Note: The application can be run with or without an instrument connected. When an instrument is not connected the application can only be used to display and analyze a previously saved log file. All the controls and indicators related to the instrument are grayed out.
To control a VSEW_mk2 using the Instrument_Manager, proceed as follows:
| 1. | Connect the instrument to an available USB connector on the PC. |
| 2. | Make sure that the charge LED lights-up yellow or green, and that the operation LED starts blinking. If not, review the installation procedure, or see section Troubleshooting. |
| 3. | Go to Start\All-Programs\Convergence_Instruments\Instrument_Manager, and run Instrument_Manager.exe. |
| 4. | The front-panel described in Figure 9 appears, and the application tries to connect to the instrument. If it fails to find the instrument it indicates No Device Found. If this is the case see section Troubleshooting. |
| 5. | Otherwise the application immediately starts communicating with the VSEW_mk2. |
